CU4WHLN
04-29-2001, 02:57 PM
Wow! Picked up 4 1/2"s of ground clearance by rotating the Dana 300 up with the kit from Go2Guy Engineering.
It's a ring that has 3 positions, I used the middle one. The T-case now sits horizontal ! I cut out the "hook" (that low hanging outhouse) on the stock skid and welded it flat.
Had to modify shifter and need a new front propshaft.. but what the hay... still worth the trip.
T-case is up 3 1/2"s and total skid plate ground clearance gain was 4 1/2"s.
Leaving for Moab This Friday... I'm sure this will pay off there !
Oh, yea, put in the TeraLow 4:1 kit at the same time. Can you say "Ready to Rock" ! (crawl, that is)
It's a ring that has 3 positions, I used the middle one. The T-case now sits horizontal ! I cut out the "hook" (that low hanging outhouse) on the stock skid and welded it flat.
Had to modify shifter and need a new front propshaft.. but what the hay... still worth the trip.
T-case is up 3 1/2"s and total skid plate ground clearance gain was 4 1/2"s.
Leaving for Moab This Friday... I'm sure this will pay off there !
Oh, yea, put in the TeraLow 4:1 kit at the same time. Can you say "Ready to Rock" ! (crawl, that is)