deserthorizons
02-09-2002, 04:09 PM
I found a spot to put the CB..
Turned out to be a much easier installation than anticipated..
It is just not convenient to mess with while driving..
Even have the coax run all the way to the back door,,
but as yet, I have not mounted the anntena..
Above the foot well is a plastic plate that removes with 2 screws..
I mounted the CB on that..
No visible mounting holes, and the CB is there for emergencies and the trail..
http://pic80.picturetrail.com/VOL970/4199859/8792386/332585920.jpg
""Any metal working people out there.??""
I want to get a piece of metal that attaches to the inside of the back door jamb,,
comes out thru the opening and bends around just above the tail light..
and then mount the antenna there..
Whether it was a side mount or a top mount would
depend on how the metal was shaped..
There would only be about 3" of coax sticking out from the door..
This way NO holes have to be drilled on the "outside" of the body..
easy, huh.??
http://pic80.picturetrail.com/VOL970/4199859/8792386/332588615.jpg
I ended up doing it myself.. very easy fab..
just bent some 16ga metal and it was flexible enough
to move out of the way of the branches..
(btw. - it never bent out of shape..)
Turned out to be a much easier installation than anticipated..
It is just not convenient to mess with while driving..
Even have the coax run all the way to the back door,,
but as yet, I have not mounted the anntena..
Above the foot well is a plastic plate that removes with 2 screws..
I mounted the CB on that..
No visible mounting holes, and the CB is there for emergencies and the trail..
http://pic80.picturetrail.com/VOL970/4199859/8792386/332585920.jpg
""Any metal working people out there.??""
I want to get a piece of metal that attaches to the inside of the back door jamb,,
comes out thru the opening and bends around just above the tail light..
and then mount the antenna there..
Whether it was a side mount or a top mount would
depend on how the metal was shaped..
There would only be about 3" of coax sticking out from the door..
This way NO holes have to be drilled on the "outside" of the body..
easy, huh.??
http://pic80.picturetrail.com/VOL970/4199859/8792386/332588615.jpg
I ended up doing it myself.. very easy fab..
just bent some 16ga metal and it was flexible enough
to move out of the way of the branches..
(btw. - it never bent out of shape..)